Board wall clamp
Board wall clamp
Wall clamps are used for attaching mounting boxes AU3.2 or AU5.2 to a 12-13 mm thick board wall. The hole diameter is 74 mm and the board clamps are placed on each side of the hole in the board. The box is pushed through the hole from behind of the board, and locks firmly between the board clamps.
-
Installation Materials
- Flush mounting boxes
- Junction boxes for flush mounting
-
Accessories for mounting boxes
- Nordic box accessories
- Accessories for ABB BeTon flush boxes (AUB67, AUB67H)
- Extension ring 2 mm
- Extension ring 4 mm
- Extension ring, 13 mm
- Extension ring 15 mm
- Extension ring, 28 mm
- Extension ring, 60 mm
- Extension ring for AU17.2
- Extension ring for junction boxes, 13 mm
- Extension ring for junction boxes, 45 mm
- Interconnectors
- Box support
- Inlets
- Strain relief inlet
- Angle inlet
- Back inlets
- Strain relief inlet
- Reducer
- Interconnector, for mounting box AUS15.2
- Plug to inlets
- Inlets for board wall mounting boxes, 20 mm
- Support for junction box
- Installation plug
- Board wall clamp
- Installation adaptor
- Screws for mounting boxes
- Protective cover
- Protective cover
- Protective cover
- Mounting fixtures to wooden or steel frames, for blue mounting boxes
- Mounting box support
- Box support for concrete elements
- Piping materials
- Covers for mounting boxes
- Surface-mounted junction boxes
- Accessories for surface mounting junction boxes
- Cable Protection and earthing materials
- Fire retardant boxes (EI30 and EI60)
- ABB system BeTon products for casting applications
- Wiring Accessories
- Signal
Visa mer
Wall clamp
Wall clamp, for 12 - 13 mm board
Typ: AS8.13 GTIN: 6410011527689 Produkt ID: 2TKA130015G1