Screws for mounting boxes
Screws for mounting boxes
Devices are attached to the mounting and junction boxes by using self-tapping PLP4 screws. The screws fit to all mounting boxes. If necessary, it is possible to raise the device up to 10 mm by using the longer PLP5 screws.
-
Installation Materials
- Flush mounting boxes
- Junction boxes for flush mounting
-
Accessories for mounting boxes
- Nordic box accessories
- Accessories for ABB BeTon flush boxes (AUB67, AUB67H)
- Extension ring 2 mm
- Extension ring 4 mm
- Extension ring, 13 mm
- Extension ring 15 mm
- Extension ring, 28 mm
- Extension ring, 60 mm
- Extension ring for AU17.2
- Extension ring for junction boxes, 13 mm
- Extension ring for junction boxes, 45 mm
- Interconnectors
- Box support
- Inlets
- Angle inlet
- Strain relief inlet
- Back inlets
- Strain relief inlet
- Reducer
- Interconnector, for mounting box AUS15.2
- Plug to inlets
- Inlets for board wall mounting boxes, 20 mm
- Support for junction box
- Installation plug
- Board wall clamp
- Installation adaptor
- Screws for mounting boxes
- Protective cover
- Protective cover
- Protective cover
- Mounting fixtures to wooden or steel frames, for blue mounting boxes
- Mounting box support
- Box support for concrete elements
- Piping materials
- Covers for mounting boxes
- Surface-mounted junction boxes
- Accessories for surface mounting junction boxes
- Cable Protection and earthing materials
- Fire retardant boxes (EI30 and EI60)
- ABB system BeTon products for casting applications
- Wiring Accessories
- Signal
